Tools List:
10x1.25 metric tap (for passenger side engine/transaxle mount)
1/4" - 1/2" tap wrench
11/32 drill bit (new) (for drilling transaxle case for accord mount)
lube for drill and tap
drill bit stopper or tape
17mm deep socket / 17mm end wrench for mount nuts
10mm deep socket for ecu nuts
36 mm (preferably impact) deep-ish socket for axle nuts
plywood or a metal, L shaped, carpenters square for making flywheel holder
torx wrenches, for TPS
ball joint puller or BFH
pry bar or ball joint fork for getting the axles loose
Flare nut wrenches for fuel and brake fittings
12 pt sockets for flywheel and clutch bolts
19mm impact socket for crank bolt
caulk gun for window weld
mechanics gloves
rubber gloves for the icky stuff
Penetrating fluid / PB blaster
primer / wire brush (for any rusty stuff)
jack stands or lift.

Parts list:
H22 Power steering hose (if youre tough and youre not going to autox- just save your money and toss the P/S.  It leeches power and a lot of revability)
H22 p/s belt
50425 A/C alternator belt for accord ac pulley/h22 crank + alternator pulleys
axles (stock, or aftermarket for accord.)
distributor screw (take the old one off and get a hex key bolt from a hardware store)
USDM H22 distributor
tune up stuff (cap + rotor (if old dist.), plugs, wires)
full 2.25 or 2.5" exhaust: H22 header, accord or universal catalytic convertor and accord catback
wire for VTEC / Knock sensor / IAB etc.  Four different colors preferably
wire for extending O2 sensor + thermostadt harnesses
wire loom and zip ties
electrical tape or heat shrink tubing
cotter pins for suspension and shift linkage
solder and solder gun
window weld (advance auto parts)
Helms manuals for Prelude VTEC and your accord
Long fuel line, AEM fuel rail, or swap over accord rail- it works but its small!
copper washers for fuel line fittings at fuel rail
fuel filter
PCV valve (the one on my H22 was bad- it will rattle if its good.  If you cant get one, spray yours out with throttle body cleaner)
heavy gauge wire for grounds, the stock accord harness grounds on my car were shot/small
ECU end of the engine harness from a junk yard for the pins to wire up VTEC etc.
sytnthetic grease
5 quarts of oil / filter
HONDA P/S fluid
coolant
transaxle fluid (redline MTL)
brake cleaner or alcohol for cleaning stuff.
thermostat
vacuum hose (silicone if you can get it)
time and patience
back to swap notes